Jump to content
C4 Forums | Control4

ajburnet

c4Forums Member
  • Posts

    46
  • Joined

  • Last visited

Everything posted by ajburnet

  1. Hi folks. I completed an upgrade on my system to OS3.3, and it appears the digital autio output on my HC800 is now disabled. This was feeding my C4 4 zone amp , and ceased to function after the upgrade unless using the analogue outputs on the controller and inputs on the amp. Anyone else come across this? Are they only supporting hi-res audio with this OS and HC800 cant manage it? Thanks!
  2. Thanks. It must have heard me as I replaced the battery earlier and its now routing via the relay again and responding! A shame I can't disable the routing feature of the ZtoIR module....
  3. Hi folks, Just trying to understand why I have intermittent behavior with card access motion sensors and lighting (via c4 puck). The lighting code is attached to the correct event, e.g. when motion is detected turn light on. For one of the two sensor + light setups I initially resolved it (assumed it might have been a mesh issue) by locating a zigbee relay in the same room. However its started playing up again, i.e. not always responding. I've noticed that the routing tree shows its not routing via the zigbee relay in the same room, but now routing via a ZigbeetoIR access module at the other end of the house. Strange that it routes via a device so far away, rather than the closest path which would be the relay or the controller directly - seems to be around 4 hops. There are no other 2.4ghz in that room or the immediate vicinity and the mesh is on ch25 so avoid wifi as best as I can. 0% packet loss inbound / outbound but I can see outbound route failures (1386) for the PIR sensors in question but not sure how relevant that is> I do have Google Wifi which I know can flood the channels - lowering its signal strength is an option if I can although all nodes for that are located away from c4 controllers etc on purpose. Any thoughts, is that routing what you would expect? All show as having strong signal. Thanks! Alex.
  4. Has anyone by any chance written a mini driver for the Plexpreview channel? Trying to find the ID but not in the store given its a private channel. Thanks
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.