Jump to content
C4 Forums | Control4

hevnbnd

c4Forums Member
 View Profile  See their activity

  • Posts

    37

  • Joined

  • Last visited

hevnbnd's Achievements

Apprentice

Apprentice (3/14)

  • Collaborator
  • First Post
  • Conversation Starter
  • Week One Done
  • One Month Later

Recent Badges

1

Reputation

  1. hevnbnd
    I figured out the issue. Firmware did not take on engine's...
  2. hevnbnd
    Ok So I have everything hooked up on my bench. I don't have control of my LEDs though. I show firmware version 5.071 in Composer. My DMX to RJ45 cable looks correct. Pin 1 goes to Brown/ Brown White on my cat 5 cable. Pin2 goes to Orange on my cat5. Pin3 goes to Orange White on my Cat 5. My cat5 is wired with standard B method. ORW/O/GW/B/BW/G/BW/B My LEDs are always RED.... They have only Pin1 on their jumper and the DMX RGB Dimmer Driver is set to 1,2,3. Where do I go from here? Anyone to call?
  3. hevnbnd
    Will the new Ethernet DMX Engine work with Control4? Any plans / time table for the driver?
  4. hevnbnd
    I have driver 2.11 installed with an EA1. Under Status I get Incompatible Firmware v4.085, 3/12/2014. Do I have to purchase the updated firmware? 2nd question. Will the new Ethernet DMX Engine work with Control4?
  5. hevnbnd
    Yea I am aware I was looking for a diagram that showed what pins go to what. Also I saw the images with all the decoder's in one location. If you install the setup that way do you just use like 22/4 wire to run from decoder out to the LEDs?
  6. hevnbnd
    Looking to use an E1 with the Response box. Have any diagrams that show the RS232 to 3.5mm cable and one that shows the XLR5 dMX to ethernet?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.

  I accept