Jump to content
C4 Forums | Control4

metroimpact

c4Forums Member
  • Posts

    6
  • Joined

  • Last visited

metroimpact's Achievements

  1. As not to assume again, can anyone confirm that I can use a DMX splitter with both the RS-232 DMX option and the Enttec IP DMX option. I am not able to daisy chain all of the DMX encoders.
  2. That makes sense. I'm curious how a chase sequence would be programmed, using only the RGB channels, if the DMX decoders are 4 channels (4th being white)? The scenario would be two 4CH DMX decoders controlling two RGBW strips with sequential DMX addresses (1-4 and 5-9 with 4 and 9 being White). Can the chase run through channels 1-3 then 5-8 while skipping the white channels (4 and 9)? Thanks for the help.
  3. I'm interested in using this driver for an RGBW install. Assuming a single 4ch dmx decoder is used to run a chain of RGBW strips, how is the 4th channel (white) treated in relation to the RGB (1-3) channels? Can all four channels be ON simultaneously or does channel 4 override (turn off) channels 1 through 3?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.