Jump to content
C4 Forums | Control4

hometheaterguy

c4Forums Member
  • Posts

    50
  • Joined

  • Last visited

  • Days Won

    1

hometheaterguy last won the day on June 2 2023

hometheaterguy had the most liked content!

Recent Profile Visitors

The recent visitors block is disabled and is not being shown to other users.

hometheaterguy's Achievements

  1. I have done overflow C4 programming for a local dealer in addition to my own system. I have basic skills, setting up small systems, hardware revisions/additions, lighting, writing simple IR or serial drivers, troubleshooting. As the result of a very messy divorce, the dealership was shut down overnight with no notice. Subsequently, all vendor accounts were closed and all employees/mine C4 accounts were deactivated. I am also a small dealer/installer in the Chicago area, but after speaking with C4 I have no interest in a path to a dealership. Anyone looking for some help, please contact me.
  2. Thank you Andrew for your help. I discovered that a glitch occurred when deleting the driver from the project. When adding the driver I noted that the info of the driver details when loaded into the project were different from the actual driver details. The project referred to a test driver I quickly wrote to test the commands but somehow was retained in the project file. I was able to sync this driver with the correct driver through the project driver screen. Now all is correct.
  3. You can go to connections and open the Reavon driver and see all the connections? What ver of Composer are you using? I am on 3.2.4.
  4. Yes, I am using the Composer driver creation tool. The file is attached. Yes when I try to make a connection using the driver, other than the serial connection, no other connections programed into the driver show up. Also, when I go to edit the driver, the I/O bar is grayed out. When reviewing the driver in Notepad, all the data is there. dvd_Reavon_UBR-X200.c4i
  5. It has been awhile since I have written a driver. This is a serial driver for the Reavon UBR-X200. The coding goes well, however, after adding the I/O info and saving the driver the I/O info is not in the driver when I go to make connections. Is this a C4 issue ? The I/O info is HDMI IN, and HDMI A/V, HDMI AUDIO, Coaxial. Optical, XLR as outputs. Also, when I try to edit the driver the I/O block is grayed out. The earlier drivers I wrote went fine. Any info would be appreciated. Also, the mfr serial info is written in hex. I recall I converted hex to decimal in the past...does it matter?
  6. Is there a way to program custom buttons in composer to raise/lower a dimmer a specific amount at each touch?
  7. It has been 3 months since this post...Any update as to when will the UDP-205 driver will be available?
  8. Can you provide an update on the release of the UDP-205 driver?
  9. Deluxe Audio/Video in Naperville for C4 and a pretty decent product line.
  10. I wrote a serial driver for the 15750 switch. If the codes are the same I would share.

    1. Neter66

      Neter66

      Thanks, I just blew the thing up somehow, so it's being RMAed.  Will try again when the replacement is delivered.

       

      Thanks
      D.

       

  11. Will the new driver be a UDP-20x to be compatible with both the 203 and 205? If yes, will it be a simple update to the existing 203 driver?
  12. I would like to convert to a IP driver as soon as we install the 205. Will the 203 driver provide basic control?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.