CFUG Posted July 31, 2014 Share Posted July 31, 2014 For as long as I've used these, I have never noticed that there seems to be no way to directly use the light level percentage in programming. I wanted to control a shade off of light level and got stopped cold. Does Nyce offer a programmable light sensor in with their motion/driver?? Link to comment Share on other sites More sharing options...
Cyknight Posted July 31, 2014 Share Posted July 31, 2014 ??? I think Nyce is the ONLY one that doesn't have light level and associated programming. Both Axxess and Card Access do.For Axxess you're looking to open the + sign and look for illumination%For Card Access you're looking at + signe, then again for device variable - LIGHT_LEVEL (also in percentage) you get the usual "When light level changes"then you go on the right and use conditionals (again break out the + to get the variables) ie "IF LIGHT_LEVEL is lower than xxx" Then program what you want... Link to comment Share on other sites More sharing options...
CFUG Posted July 31, 2014 Author Share Posted July 31, 2014 then you go on the right and use conditionals (again break out the + to get the variables) ie "IF LIGHT_LEVEL is lower than xxx"The driver installed for this motion (older install BTW) stops with contact state when expanded. So the driver is NG? Link to comment Share on other sites More sharing options...
Cyknight Posted July 31, 2014 Share Posted July 31, 2014 Must be - not sure how many version there have been, but either it's some older one or a corrupt driver. Only motion driver I know that limits it to just contact state is the generic motion driver Link to comment Share on other sites More sharing options...
CFUG Posted July 31, 2014 Author Share Posted July 31, 2014 ^Sounds about right- Thanks. Link to comment Share on other sites More sharing options...
JP Rizal Posted August 2, 2014 Share Posted August 2, 2014 Yes I've been using the light level in programming from day One I've also tested the other motions from NYCE and Access from memory CA is the most flexible and friendly to program Link to comment Share on other sites More sharing options...
CFUG Posted August 2, 2014 Author Share Posted August 2, 2014 Yeah, I think we determined the generic driver was installed. Dealer has fixed that. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.