AceOfSpades Posted September 13, 2015 Share Posted September 13, 2015 I am struggling to get two keypad dimmers working on 3-way lights. Both dimmers are flashing green lights and I am unable to add them to the project? Any ideas would be greatly appreciated. Link to comment Share on other sites More sharing options...
RyanE Posted September 13, 2015 Share Posted September 13, 2015 2 dimmers trying to control the *same* load, or *two different* loads on *two separate* 3-way circuits? RyanE Link to comment Share on other sites More sharing options...
Cyknight Posted September 13, 2015 Share Posted September 13, 2015 To get you ideas we'd need more information, starting with what Rytan said, what els is on the 3 way, wiring etc.. Link to comment Share on other sites More sharing options...
AceOfSpades Posted October 3, 2015 Author Share Posted October 3, 2015 To get you ideas we'd need more information, starting with what Rytan said, what els is on the 3 way, wiring etc..Two keypad dimmers controlling the same load. Link to comment Share on other sites More sharing options...
AceOfSpades Posted October 12, 2015 Author Share Posted October 12, 2015 Any ideas on whether this is doable? I have quite a few of these Keypad Dimmers. I don't want to purchase any Aux Keypads. Link to comment Share on other sites More sharing options...
whitneyd Posted October 12, 2015 Share Posted October 12, 2015 You can use a configurable keypad instead of an auxiliary keypad Link to comment Share on other sites More sharing options...
SMHarman Posted October 12, 2015 Share Posted October 12, 2015 Any ideas on whether this is doable? I have quite a few of these Keypad Dimmers. I don't want to purchase any Aux Keypads.One would be connected to the load. The second location would need cont power and nothing to the load so it would look like a keypad not a keypad dimmer. Then the second on with no load is programmed to operate the load on the first. Binding the light scene is good for speed and to get the leds to follow correctly. Sent from my LT26i using Tapatalk Link to comment Share on other sites More sharing options...
Cyknight Posted October 13, 2015 Share Posted October 13, 2015 If you HAVE the keypad dimmers - you'd cap off the red wire and use it as a keypad. Messy in the system but works. Link to comment Share on other sites More sharing options...
Mntneer Posted October 13, 2015 Share Posted October 13, 2015 C4 makes 3 way circuits almost pointless. Use 1 keypad dimmer as your load control and use the other keypad dimmer as a programmable keypad, just be sure of your power/neutral wires when wiring the 2nd keypad. I do wish that C4 had an Aux Switch that had LED's like the standard switches, to give a more uniform look, as well as regular 2 pole, 3 pole light switches so that clients can maintain a uniform look throughout their house. Finding rocker switches that match the C4 switches is impossible. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.