I had two wireless dimmer's to install. One in the master bedroom and one in the master bathroom. I got the master bedroom dimmer installed and added to the project. It immediately started updating its firmware once it joined the project.
I then moved on to installing the wireless dimmer in the master bathroom. As it turns out the master bathroom and bedroom are both on the same circuit. I shut off the circuit while the master bedroom dimmer was in the middle of updating its firmware. Now under Network tools, Zigbee Network in Composer it shows that the update failed. The LEDs are flashing blue as if the dimmer is still in the progress of updating. Is there a way to restart the update? I've attempted the 9-9-9 factory reset but that didn't seem to do anything. Suggestions?
Question
dutsnekcirf
I had two wireless dimmer's to install. One in the master bedroom and one in the master bathroom. I got the master bedroom dimmer installed and added to the project. It immediately started updating its firmware once it joined the project.
I then moved on to installing the wireless dimmer in the master bathroom. As it turns out the master bathroom and bedroom are both on the same circuit. I shut off the circuit while the master bedroom dimmer was in the middle of updating its firmware. Now under Network tools, Zigbee Network in Composer it shows that the update failed. The LEDs are flashing blue as if the dimmer is still in the progress of updating. Is there a way to restart the update? I've attempted the 9-9-9 factory reset but that didn't seem to do anything. Suggestions?
Link to comment
Share on other sites
4 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.