JustJay2 Posted June 11, 2017 Share Posted June 11, 2017 Looking for help from anyone that has run into this EA-5 error light! System locked up last night, I have a red triangle with an exclamation point on the the front panel. I power cycled with no change, did a factory reset and now instead of a solid light, it is flashing. I have never seen this before and there is nothing found in the knowledge base. I am dead in the water at this point, any help would be appreciated. - Jay Link to comment Share on other sites More sharing options...
South Africa C4 user Posted June 11, 2017 Share Posted June 11, 2017 31 minutes ago, JustJay2 said: Looking for help from anyone that has run into this EA-5 error light! System locked up last night, I have a red triangle with an exclamation point on the the front panel. I power cycled with no change, did a factory reset and now instead of a solid light, it is flashing. I have never seen this before and there is nothing found in the knowledge base. I am dead in the water at this point, any help would be appreciated. - Jay I had something similar a few months ago and ended up down for a couple of days needing a new EA5 Hope you have better luck! Link to comment Share on other sites More sharing options...
VINCELdUB Posted June 11, 2017 Share Posted June 11, 2017 Rma needed. Same thing happened to me two weeks ago. Happy Automating!! Link to comment Share on other sites More sharing options...
Matt Lowe Posted June 15, 2017 Share Posted June 15, 2017 have any you tried a usb restore on a controller in this state? Link to comment Share on other sites More sharing options...
JustJay2 Posted June 15, 2017 Author Share Posted June 15, 2017 Yeah, that didn't work either. RMA replacement was required. So did any of you guys notice that ZigBee response was "sluggish" prior to failure? Link to comment Share on other sites More sharing options...
South Africa C4 user Posted June 17, 2017 Share Posted June 17, 2017 On 6/15/2017 at 11:43 PM, JustJay2 said: Yeah, that didn't work either. RMA replacement was required. So did any of you guys notice that ZigBee response was "sluggish" prior to failure? Yes Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.