2TimeOlympian Posted January 28, 2018 Share Posted January 28, 2018 I was building a new home theatre and the company sold me on the Control4 EA-1 Smart Home Controller. He said it also acted as a ZigBee router so I went and purchase 2 Stelpro Orleans High-End Convectors. Unfortunately upon further investigation the only company that has a driver for these products is VERA Smart Home Control. I have attached the instructions to hook up the Convectors to the ZigBee network but the dealer was unable to do so, I assume because there is no C4 driver. Does anyone know if it's possible to build a driver for this or have the dealer connect it as a generic device? Your help is greatly appreciated. STZB402_EN.pdf Link to comment Share on other sites More sharing options...
sonic30101 Posted January 28, 2018 Share Posted January 28, 2018 Control4 uses a specific zigbee protocol, but you may be able to integrate vera into the system and control it from c4 that way Link to comment Share on other sites More sharing options...
msgreenf Posted January 28, 2018 Share Posted January 28, 2018 Control4 uses a specific zigbee protocol, but you may be able to integrate vera into the system and control it from c4 that wayLike sonic said it's more then a driver. It will require a different zigbee stack in the hardware Sent from my Pixel XL using Tapatalk Link to comment Share on other sites More sharing options...
vstar Posted January 30, 2018 Share Posted January 30, 2018 just throwing this out there as a possibly solution, could he not setup a Vera controller and Vera C4 driver and control it through that possibly? kinda a round about way and extra cost but may be the only way? Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.