KNX lighting and Control4

[XCD]

Can someone point me in the right direction for control4 integration of KNX lighting? How does it work exactly? Control4 switches are a bit limiting for me, and any light switch with more customizability is a great boon for me. 

[blub]

You get a KNX switch or dimmer and and a keypad.
Furthermore a power supply and a IP gateway.

Then place the dimmer or switch either where your brakers are if you are doing KNX with bus wires or in your wall boxes if you are retrofitting - the latter solution requires KNX RF (system mode preferred) or PowerNet.
KNX then needs to be programmed via ETS5 and then the components added to Control4 via drivers and the KNX addresses from the bus.