Jump to content

Reconfigure Temp. Display Driver

Recommended Posts

I have found that when using a C4- Z2C with a remote sensor to monitor hot water lines for boiler systems, wood fired boilers and hot water lines the temperature display driver limits its display to 120 degrees in navigator. It would be real helpful to redesign the temp. display driver to allow it to follow the limits of the remote thermistor so items like this can be displayed in navigator and not just a - once the temp gets above the threshold which I think is around 120 degrees F.


Thanks in advance,



Share this post

Link to post
Share on other sites

I ran into this same issue with a thermostat controlling a water heater temp.  It wouldn't display any temp over 119F.  My work around was to change the scale to C.

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now