mikenberg

AT&T Uverse remote code mappings

5 posts in this topic

Does anyone know how to successfully map Uverse remote comamnds to C4? I have tried updating the macro to capture the IR codes from the Uverse remote but can't seem to get the box to respond to my IR flashes when I perform the task using the mapped buttons on the C4 remote.

Any history or input anyone may have on getting Uverse integrated into my C4 system is greatly appreciated.

Regards,

Michael

Edited by mikenberg

Share this post


Link to post
Share on other sites

I have succesfully controlled a Uverse box with C4. You should try using emitter shields and non-blinking IR emitters.

Share this post


Link to post
Share on other sites

I just finished adding the uverse box to my system. I did not program the remote, I just used the out of the box driver for the Motorola box that AT&T uses. To ensure a tight fit and shielding, I prefer a little black tape :-p over the sensor. The only button I noticed is missing is the "back" button so when you are browsing dvr or on demand, you need to start over each time, which is a little annoying. I have not decided on which button to reprogram... Maybe the recall ?

Share this post


Link to post
Share on other sites

Super necro bump but does anyone have trouble with the RECALL not working?

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!


Register a new account

Sign in

Already have an account? Sign in here.


Sign In Now
    • 3 Posts
    • 23 Views
    • 2 Posts
    • 51 Views
    • 2 Posts
    • 64 Views
    • 9 Posts
    • 186 Views
    • 2 Posts
    • 142 Views
    • 1 Posts
    • 118 Views