Jump to content
C4 Forums | Control4

Wyrestorm MX-0404-STD matrix (not serial port)


hank31980

Recommended Posts

Advice required.

 

I purchased a while back a Wyrestorm Video matrix MX-0404-STD.

However, I made the wrong assumption that it would hook straight up to Control4 system, because I saw that there was a MX-0404 driver available, but didn't check on control method, i.e. serial for this device.

 

The model I have has no RS-232 port, so the online driver I guess is of no use. There is just an Infra Red input to the device as it comes with a small dedicated remote controller.

What would the best way of hooking this up, would it be possible to edit existing available C4 driver or simply create a new one by input the IR codes by a learning process from existing Remote control?

 

Regards

 

hank31980

Link to comment
Share on other sites


The 4040 online driver is for a UTP matrix. For the STD matrix you will need to find / make a IR driver as it's the only way it can be controlled.

I appreciate it's a bit late for you as you already have the wyrestorm - but CYP have a HDMI matrix with serial control and C4 drivers:

http://www.cypeurope.com/store/store/app/browse/category/21008/Matrices/HDMI-Matrices/4x4-HDMI-Matrices/

 

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.