Jump to content
C4 Forums | Control4
  • 0

Honeywell 21IP c4 help




I had my honeywell security guy install outdoor gate/door sensors and add them to my vista panel.  He added them so they wouldn't trip the alarm since the wind would wreak havoc...LOL.  But I cannot get the system to import those zones into the c4 interface.  They show up in the navigator but not in the zone list on the panel driver.  Therefore I cannot change the normally open or closed or program off of them.  Are there restrictions on what type of zone the driverworks can import?  




I can post more if needed but it's still registering the status of the zones that are there correctly.  Any help is appreciated.


Thank you,

Link to comment
Share on other sites

1 answer to this question

Recommended Posts


This topic is now archived and is closed to further replies.

  • Create New...