timbooo Posted November 21, 2018 Posted November 21, 2018 I have a situation where a 2N entry keypad was installed and connected to a large whole-house C4 system. Of course it's 99.9% the same product so everything has been fine. However "Intercom Anywhere" has thrown a spanner in the works. Even though it's essentially a DS2 with a 2N logo on it, it cannot be used. Yes I know there is the 2N app that could be used instead but apparently that's undesirable. I'd like to know if anyone has ever tried/managed/failed to flash a DS2 firmware image to a 2N Helios IP Verso (thus turning it into a DS2).
eggzlot Posted November 21, 2018 Posted November 21, 2018 2 hours ago, timbooo said: I have a situation where a 2N entry keypad was installed and connected to a large whole-house C4 system. Of course it's 99.9% the same product so everything has been fine. However "Intercom Anywhere" has thrown a spanner in the works. Even though it's essentially a DS2 with a 2N logo on it, it cannot be used. Yes I know there is the 2N app that could be used instead but apparently that's undesirable. I'd like to know if anyone has ever tried/managed/failed to flash a DS2 firmware image to a 2N Helios IP Verso (thus turning it into a DS2). i havent tried but I have a 2n Helios and use their app and it works just fine. either way is a two app solution, no?
timbooo Posted November 21, 2018 Author Posted November 21, 2018 1 hour ago, eggzlot said: i havent tried but I have a 2n Helios and use their app and it works just fine. either way is a two app solution, no? Yes but with intercom as well (phone to touch panels, admittedly unlikely) it becomes three apps.
eggzlot Posted November 21, 2018 Posted November 21, 2018 Hm. I just use 2. Don’t think a 3rd is needed?
Recommended Posts
Archived
This topic is now archived and is closed to further replies.