therockhr Posted August 16, 2019 Share Posted August 16, 2019 Anyone using global cache relays? I am trying to use one for a garage door and it will turn the relay on but it never turns off, it stays closed. Quote Link to comment Share on other sites More sharing options...
jamesc4 Posted August 18, 2019 Share Posted August 18, 2019 Which model Can you provide a link did you reach out to Global Cache support ? They are very helpfull Quote Link to comment Share on other sites More sharing options...
therockhr Posted August 18, 2019 Author Share Posted August 18, 2019 Well once I got switched over to using the experience button for garage doors it works. Not for sure what the deal was. Quote Link to comment Share on other sites More sharing options...
Matt Lowe Posted August 18, 2019 Share Posted August 18, 2019 5 hours ago, therockhr said: Well once I got switched over to using the experience button for garage doors it works. Not for sure what the deal was. likely some setting in the relay driver. there are ones that will toggle or just reset to the original position after completing the circuit Quote Link to comment Share on other sites More sharing options...
therockhr Posted August 18, 2019 Author Share Posted August 18, 2019 40 minutes ago, Matt Lowe said: likely some setting in the relay driver. there are ones that will toggle or just reset to the original position after completing the circuit Yeah looking at the Lua output it wouldn’t ever go back to open. It would go to close then open and just stay there. Quote Link to comment Share on other sites More sharing options...
indecision Posted August 20, 2019 Share Posted August 20, 2019 I have a GC-100-12 in my setup. It is one of their older units but I do use the relays for to open/close my garage doors. It works well but I seem to be experiencing some delay when sending commands. I am running OS3. Anyone else seeing any delays using a GC unit? Quote Link to comment Share on other sites More sharing options...
zaphod Posted January 8, 2023 Share Posted January 8, 2023 Did you ever figure out what was going on here. I am trying to use one and getting the same thing. The relay is always closed other than when you cause it to toggle or whatever. But it keeps going back to a close state. I am using a GC-100-12. There really isn't any setup for the device and the relay has two wire contacts, not three like C4 devices that have Com, NC and NO. Quote Link to comment Share on other sites More sharing options...
Amr Posted January 14, 2023 Share Posted January 14, 2023 On 1/8/2023 at 6:23 AM, zaphod said: Did you ever figure out what was going on here. I am trying to use one and getting the same thing. The relay is always closed other than when you cause it to toggle or whatever. But it keeps going back to a close state. I am using a GC-100-12. There really isn't any setup for the device and the relay has two wire contacts, not three like C4 devices that have Com, NC and NO. I only used it for IR and serial, but if u have only 1 wires then its NC unless u change it from the UI, did you tried to use web UI to configure it? Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.