Jump to content
C4 Forums | Control4

Anyone have CAD experience?


Recommended Posts

There wasnt a really good place to post this, so I figured I would try here... I am getting a custom floor medallion made but the company I was ordering from is going out of business. They had sent me an image of the medallion but not the CAD file, and my new contact said for a custom medallion I need someone to send him a CAD file. Can anyone here take the jpg image I have and map/design it in CAD for me? It is relatively simple to do from what I have been told since it is symmetric vertically and horizontally.

Link to comment
Share on other sites

  • 2 months later...


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.