Jump to content
C4 Forums | Control4

For Sale: Complete Just Add Power (JAP) 2G System


Recommended Posts

Complete Just Add Power (JAP) 2G Solution for sale.  The JAP devices were just removed from my Control4 system where they were functioning 100% fine apart from the 3 units specifically mentioned below.  The switch is configured w/ the BlackWire driver/configuration.  I am selling the following items as a set:

  • Cisco SG300-10P Switch
    • 10 Port Gigabit PoE Managed Switch includes rackmount ears and power supply
  • Two (2) 2G Receivers
  • Four (4) 2G Gigabit Receivers
  • Units that may need new firmware and/or a factory reset:
    • Two (2) 2G Receivers
    • One (1) 2G+ Enhanced Gigabit Receiver 
  • Five (5) 5V Power Supplies

My dealer told me that he could probably update the firmware on these to get them back up and running again. I did not attempt to do so nor did I ask him to do so.  There is a chance that these three (3) devices could be dead.  All other products were working fine.  Note that on a couple of the units, we removed the mounting arms to allow for Velcro mounting.

I would prefer to sell the whole solution as a set.  If no interest after a while, I will consider selling off units individually.

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...