Jump to content
C4 Forums | Control4
  • 0

DS2 Lock Programming



Hi all,

Trying to program the following and would like some advise. I have the following setup:

  1.  Front Gate that is connected to EA5 Relay 1. This is for open and close.
  2. Front Gate also has a contact switch to EA5 Contact 1. This is so that I can see if the gate is open or closed.
  3. DS2 with touch screen at the front gate.

What am I trying to do:

  1. I added three users with access codes and day / time restrictions - in order:
    1. My Gardener
    2. My House Minder
    3. My Handy Man


I want to open the front gate if any of the individual enter their respective codes and its accepted (correct).

Here are my bindings for the DS2 and the Locks:

  1. Door Bell Lock Bindings - DoorBellLock.JPG
  2. Lock Bindings - DB Lock.JPG
  3. DS2 Bindings - DS2.JPG
  4. Gate Bindings - Gate.JPG

I looked at the programming and I see there is :

User Code 1 Entered - now does that mean in my list above "My Gardner" enters his *correct* code then I can do something? Right now I just set it to a test notification to see if it works

Same for User Code 2 etc etc etc.

The restrictions are all off at the moment because when I go to the DS2 and select entry (on the touch screen) type in the correct code for "My Gardner" - I get unauthorized (yes its the right code).

How would one go about setting this up?






Link to comment
Share on other sites

4 answers to this question

Recommended Posts

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

  • Create New...