hunger Posted October 23, 2009 Posted October 23, 2009 I want to take an existing set of IR emitters connected to a Xantech 791-44 IR Amplified Connecting Block currently driven by an IR receiver and also drive those same IR emitters from an HC-300.Can I connect the IR output from an HC-300 to the IR IN and GND terminals on the Xantech? If so, the Xantech manual says that you can wire multiple IR receivers in parallel and connect them to the IR IN terminal. Can I connect other IR receivers in parallel with the Control4? If not, is it safe to connect an IR receiver to the IR RCVR jack and the Control4 to the IR IN and GND terminals?
henniae Posted October 23, 2009 Posted October 23, 2009 You can hook the C4 IR output the the IR in and ground of the 791-44, I have done this many times. I am not sure if it is safe to have the existing IR receiver hooked up with the C4 system.
hunger Posted October 23, 2009 Author Posted October 23, 2009 Thank you, Alan. Anyone know if both can be connected?
Recommended Posts
Archived
This topic is now archived and is closed to further replies.