Amr Posted July 26, 2022 Share Posted July 26, 2022 Since the update to OS3.3 (I believe) and I have this erratic behavior, never knew about it until recently, if the controller restarted or rebooted in any form, I loose control to my Panelized lighting/Dimmers, I regain control only if I power cycle them!? Does any one encounter such a thing? Affected Modules: 1 x 8-Channel Relay (C4-DIN-8REL-E) 2 x 8-Channel Dimmer (C4-DIN-8DIM-E) Quote Link to comment Share on other sites More sharing options...
Neo1738 Posted July 27, 2022 Share Posted July 27, 2022 Haven't noticed anything like that on mine. Quote Link to comment Share on other sites More sharing options...
Andrew luecke Posted July 27, 2022 Share Posted July 27, 2022 On Ubiquiti, if you have STP instead of RSTP set (or if you have set your network to the old STP path costs on any other), it causes issues. If you're using STP, try turning it off on the ports on the panelised lighting ports. Other than that, haven't seen a similar issue Quote Link to comment Share on other sites More sharing options...
Amr Posted July 28, 2022 Author Share Posted July 28, 2022 On 7/27/2022 at 8:29 AM, Andrew luecke said: On Ubiquiti, if you have STP instead of RSTP set (or if you have set your network to the old STP path costs on any other), it causes issues. If you're using STP, try turning it off on the ports on the panelised lighting ports. Other than that, haven't seen a similar issue Not using STP and turned off everything on My Cisco Managed switch that had been working since day one and basically I don’t touch! Quote Link to comment Share on other sites More sharing options...
cybuch Posted July 29, 2022 Share Posted July 29, 2022 I have the same issue. I just hit channel one 15 times to reboot it and it connects, but what a pain Quote Link to comment Share on other sites More sharing options...
Amr Posted July 30, 2022 Author Share Posted July 30, 2022 4 hours ago, cybuch said: I have the same issue. I just hit channel one 15 times to reboot it and it connects, but what a pain The only way is to schedule a power cycle after every project load, which require additional hardware for the power cycle, so it’s clearly a bug and am not alone! Hate to see this happens to a-used-to-be-stable hardware! Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.