Jump to content
C4 Forums | Control4

Interlogix Concord 4 Question:


anon2828

Recommended Posts

Q: I have a door that has a wireless sensor on it.  I would like to delete this sensor and instead use the wired sensor (reed type - 2 wire magnet) that was also at the same door but never installed during construction.

1) What do I need to do to delete the wireless sensor for the door?

2) What do I need to do to have the panel use the wired sensor (I think the wire is not connected in the panel) - is there a certain relay it needs to be on, or any open?

3) What programming steps do I need to do to get the wired sensor to be the same name, zone, etc of the previous wireless sensor.

4) Anything need to be updated in Control4 (*using the Serial Bus adapter) or will it all work automagically?

* Also, maybe I am very late to the party, but it looks like perhaps Interlogix is not totally dead and that Carrier purchased them?  Does this mean continuing parts and support?

Many thanks!

Link to comment
Share on other sites


On 9/19/2022 at 11:21 AM, anon2828 said:

Q: I have a door that has a wireless sensor on it.  I would like to delete this sensor and instead use the wired sensor (reed type - 2 wire magnet) that was also at the same door but never installed during construction.

1) What do I need to do to delete the wireless sensor for the door?

2) What do I need to do to have the panel use the wired sensor (I think the wire is not connected in the panel) - is there a certain relay it needs to be on, or any open?

3) What programming steps do I need to do to get the wired sensor to be the same name, zone, etc of the previous wireless sensor.

4) Anything need to be updated in Control4 (*using the Serial Bus adapter) or will it all work automagically?

* Also, maybe I am very late to the party, but it looks like perhaps Interlogix is not totally dead and that Carrier purchased them?  Does this mean continuing parts and support?

Many thanks!

I would reference the Concord 4 installer manual available on google for adding and deleting sensor, as far as the c4 part goes it should automatically update. 

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.