Jump to content
C4 Forums | Control4

Square Dual Load Wireless Switch - turn off standalone feature


Recommended Posts

Hello all!

 

Silly question, I guess.

I have two square dual load wireless switches. Manual says, by default its keys work as toggle switches: half for the load 1 and another half for the load 2.

Buttons are set up in the composer for different functions, both keypads are in the network and online. System reacts for button pressings accordingly. However it continues to toggle both loads as it's still in standalone mode.

For example, load 1 is connected to blinds motor and button 1 controls the light, which is controlled by 8-ch relay switch somewhere in the system . When button 1 is pressed, it turns on the lights as it should, and at the same time toggles blinds motor, which is not in the program.

I was unable to find any settings in the composer to turn off this behavior. And I see no hardware switches, jumpers or something.

 

any suggestions?

Link to comment
Share on other sites


Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.