Caseta Lamp Dimmer integration

[Caps]

Has anyone had any luck getting Lutron lamp dimmers to integrate into C4?  I have not been able to get any of them to operate.  I am using a lamp dimmer and a pico on the wall to control them.  I have the lutron smart bridge thought I cant find any information as to if this is possible or not.

 

 

[Cyknight]

Pretty sure you would just add it as a dimmer and use the ID?

[DanITman]

14 hours ago, Caps said:

Has anyone had any luck getting Lutron lamp dimmers to integrate into C4?  I have not been able to get any of them to operate.  I am using a lamp dimmer and a pico on the wall to control them.  I have the lutron smart bridge thought I cant find any information as to if this is possible or not.

 

 

Works fine, use the leap integration. Any caseta hub should work. Were you able to pair the hub?

[c4toys]

enable telnet, send integration report with id's, set ip address in driver, add dimmer driver and make appropriate connection to the leap driver

[DanITman]

On 12/14/2024 at 2:26 PM, c4toys said:

enable telnet, send integration report with id's, set ip address in driver, add dimmer driver and make appropriate connection to the leap driver

I didn't think telnet was needed for leap.  Telnet was the old integration method and leap is the new method.