t_rebert Posted May 9, 2010 Share Posted May 9, 2010 I am sorry to ask as this is probably so easy, but I can't seem to figure it out. My SR250 remote was having problems, so I checked the forum, for possible solutions. I did the "hold the red 4 button with the 0 while re-inserting the batteries" and now it is stuck in that mode and cannot find the network. My question is, how to get it out of this mode and back to "room" mode?Thanks in advance for your help. Link to comment Share on other sites More sharing options...
tigrzeye Posted May 9, 2010 Share Posted May 9, 2010 What does the screen show? Have you tried just removing the batteries and then replacing (make sure they are good fresh batteries) them WITHOUT holding the 0 and red 4 button? Link to comment Share on other sites More sharing options...
t_rebert Posted May 9, 2010 Author Share Posted May 9, 2010 Thanks for replying. I have just replaced the batteries with brand new batteries without holding 0 and Red-4, but with no luck. When I hit "Watch" is says "Test Ch..." and when I hit "Listen" is shows "-Power-..." When I hit the Blue Button it shows "-Piezo Test-" and so on with the other buttons.Thanks again for your help in this. Link to comment Share on other sites More sharing options...
t_rebert Posted May 9, 2010 Author Share Posted May 9, 2010 Well, it is back to the beginning. Took about 3 days. I put brand new batteries in like I said above, but this time I held the Red-4 and the 0 button down and it came back to the original mode. Now my problem is, it is offline. I guess I will be calling my dealer to fix.Thanks again for the response earlier! Link to comment Share on other sites More sharing options...
tigrzeye Posted May 9, 2010 Share Posted May 9, 2010 Just for the heck of it, try pushing the red '4' - 4 times. It might recognize the remote back into the system. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.