Jump to content
C4 Forums | Control4

Teammac

c4Forums Member
  • Posts

    21
  • Joined

  • Last visited

Everything posted by Teammac

  1. Got it working. RIS Mode *91 on panel set to "8, 2". Read a lot of instructions stating newer panels don't need programming for RIS Mode. Tried it on my Vista 21ip and bingo! Posting in case anyone else runs into this issue.
  2. Just installed a wired basic contact sensor. Installed and connected drivers, sensors don't respond in C4. If I close the sensor the system shows ready in C4, open it and system immediately changes to "not ready to arm" but nothing for the sensor itself.
  3. Yes. In the driver, under Security Panel, Partition 1, the zones auto populated. The motions are listed as "motion sensors". "State" box is checked, "Can Control" is not checked.
  4. I have the zones set as (04) Interior Follow , Partition 1, Report Code 20, normally closed. Various names ie, "Family Room Motion".
  5. Hello. I've searched online and haven't found this particular issue so looking for some help. I installed a Honeywell Vista 21IP with a 4232CBM. C4 is on OS3. Everything connected fine and C4 sees the alarm system, arm, disarm, status, all work fine. Within the alarm system, wired motion sensors work fine however, they do not respond in C4. The motions appear in UI (Person walking) but don't show motion when tripped. I added generic motion sensors and made the connections, still don't activate. Any ideas or help? Thanks
  6. I have a mix of Axis and Hikvision IP cameras. Driver works great with the Axis cameras but won't send an image with Hikvision. I can paste the snapshot URL in a browser and get an image with no auth needed. Any ideas on what I might be missing?
×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.