Thank you for response. No, no mockupancy setup. ...just weird..just keeps turning on all lights... could this be a defective switch somewhere in the house(i.e hardware only) or could the zigbi network be affected by others on same frequency?
Good Morning,
Recently, I noticed that my programmed Control4 lights turn on the entire home (switches are programmed thoughout the home) in the middle of the night without anyone pushing a button.
Does anyone have any ideas what the cause may be?
Thank you in advance for your help.
Ok, great, since my system is quite old, I will follow your advise...and chill for now with my working composer.
In any case you definitely have hero status with me for today!
Thank you again,
Mariano
u da BEST!!!!
Thank you so much for your reply. I was able to get it going. Since you seem to know your way around ....can I get your opinion on upgrading to next level . ie. from my current 2.53 to to the latest or will that give me problems?
Really grateful for your help with restoring my system!
Mariano
I really need help...
After C drive crash I have rebuilt everything except C4 Composer HE. When trying to register I keep getting the same message regardless of version I try to install. I have literally tried 2.4, 2.5.3, 2.72, 3.X....nothing works. I do have a account code from the original install HE1.3 and an account and a local Controller HC 800. before crash I was on Composer HE2.5.3
Does anyone on this forum have any suggestions? I am attaching the messages I keep getting .
Thank you Mariano
Thank you for you help.
It is only on the initial(1st screen - the one in the picture) C4 interface menu. It completely disappears when I go on further into the menus and also watching...no interference beyond the initial screen. I will try to unplug all(also Matrix) of them and plug back in.
this one started it about a month ago, and I begin to notice it sometimes on others as well...
so basically this one plus one more, but the second does show it only very little...
HC800 Master and a few additional HC200 local controllers full house install....interfaced on TV's throughout the home....recently I started to get on-screen interference at startup, which completely dissipates once I click through to me final selection (Cable, Music...)
what could cause this?
Thank you in advance, Mariano