Ctsvnino

Yes. This is what happens

So I we have a c4 video matrix 6x6. All sources going into matrix works. The output 5 and 6 works but get green lines on tv. the setup matrix sources in input-roku,Kaleidescape,FiOS,luma cameras, output 6 or 5 marantz receiver marantz sr5015 to av pro edge 70ex balun so only on living room tv the source don’t show. It goes on but it’s green and distorted. We tried another cat6 wire, new hdmi cables still the same. We hooked up another tv still the same. All other TVs in house are perfect. What I don’t get is it there balun, cables,matrix or tv? I calibrated it multiple times. Only living room tv didn’t work. Tv is Samsung w80r 75” please let me know need to try to fix before Christmas Unless matrix is bad which is what I’m leaning to

Need 1 switch c4-sw120 white. Located in nj. I’m getting old on rma but want to get this going before weekend and then swap it out when I receive.

Control4 sees light on and light on. I will check the driver.

Hello everyone. Hope everyone safe during these times. So this is mind boggling. Can’t figure it out. I have a wireless switch connected to low voltage lighting for under island. The light turns on by itself. Over and over. Looked in programming can’t find no timers just to make sure. Only Thing I can think of is interference or it’s the switch. What is your opinion?

Samsung q80 with Atlona HDR-EX-70-2PS with a marantz 5014 and c4 video matrix. I see the inputs switch. I hear audio but no picture. Atlona shows it’s linked and receiving. It was working yesterday and day before. Today client tries it no good. Shows no signal input. Check for updates and firmware all up to date. Could be the Atlona is bad or matrix output? Just shows no signal out

The programmer I hired keeps stating no connection. He bought the drivercentral driver. Now thermostats are set to autmation I have him the IP address. Is there anything I can tell him? The rate I’m going went threw 3 subs all lied sold me wrong stuff, went threw one programmer because he didn’t know crap. So can someone please help me to get him to finish and I can have my house normal

Guess my topic not interesting lol

I have American lighting led tape light dimmable white. Want to add more lighting under island. I have the American lighting power supply. What ballast will work with c4 to control threw touch pad. Can’t run wire threw house due basement finished and everything goes to media room. Any feed back will help thank you

Brand new In box have handle also sold separately!! Asking 450 for the lock

Brand new ordered one to many $200 located nutley nj

Hello everyone. So the house were working on is new construction and want to control the fireplace. As we all know c4 discontinued the fireplace switch. So been reading about and so far best option is a cardaccess relay. Since the electrician doesn't want to wire nor touch which I think they just don't their ass from their elbow lol. So since this is something I don't want cause problems or blowing it up. How can I know what to connect to fireplace to make this work? Will post link to model and manual. If anyone can help me please do.Fireplace link