jgmass1

Thanks for the replies so far. Problem started several months back - but has gotten progressively worse. A re-boot of the entire network helps for ~1 day, but then comes back with increasing frequency. There were some changes: addition of the Zwave module to control two Zwave outlets plus a 2nd SR260 remote; A new Wifi AP (Ubiquiti) for the network I'll check the CPU usage tonight. Thanks again

Need some guidance on where to start to debug an erratic system. Symptom: Significant lag time (20 to 30s) in system response to a SR260 remote command (pwr on or off; channel up/down; vol up/down; etc), as well as Alexa voice command, and a scheduled macro. System: 1 EA3 and 1 EA1; EA3 is in Master Bedroom; EA1 in Family room; Have Caseta lighting integrated (20+devices) + Vera Plus with motion sensors + Alexa units in various rooms + C4 Zwave module. House has multiple WiFi AP's for coverage I am thinking network issues, but also could be radio interference. Any thoughts/direction is appreciated

So - I added the Vera ZWave security sensor driver, and it is bound to the Vera Controller. The ZWave security sensor is connected to the generic motion sensor. When I run my hand over the actual sensor - I can see a change of state to closed (verified = Yes). So it seems to be working. Under programming: When the Motion sensor senses motion: If specific light is off, then turn on that light When the Motion sensor stops sensing motion: If specific light is off, then turn off that light When I hit the execute button for each script, they each execute. I have many other events tied to similar logic - just cannot seem to have the motion sensor trigger simply turning on a light

Trying to integrate Veraplus into C4. Have the Vera driver connected - "Vera connection successful - Full device data downloaded. I then loaded a generic motion sensor. Under properties of the Zwave controller, I have the zwave management link listed under inputs - but there are no sensors to bind to. Some questions: 1. Where will I see the devices in Vera? 2. How do I bind the motion sensors to Vera? Thanks in advance