Peter79

Hi, I’m having a little trouble with the above. Basically I’m struggling to get an 8 channel 0-10v to connect to my network. I couldn’t see it on the router pool so I defaulted the network settings, still nothing so factory restore which I could then see the default 192.168.1.200 in router table but this disappears after about 30 seconds. For the 30 seconds I get I can identify it in composer and it shows it as online, although it doesn’t Pre populate firmware version, temperature etc. Can’t ssh or ping it either or login to it with the web browser. I’ve tried changing the ip settings in composer within the 30 seconds and applying but it doesn’t work. Tested cable all ok, it’s wired via an un-managed switch but I’ve also tried with this bypassed. I did have an ip conflict at first with the .200 but have changed the other device ip now. Any advice would be greatly appreciated. Many thanks

Hi guys, thanks for all your help, managed to get it sorted, it was to do with the end points, my own silly mistake. hope you all have a good Christmas. thanks

Hi Rav, I installed all the play ones and amp via sddp then added the latest driver. I’m wondering if it’s anything to do with the boost? Thanks

Hi thanks for the reply, will double check shortly but pretty certain I’m using the latest one, cheers

Hi, I don’t do many c4 installs to be honest and it’s been a while since integrating sonos. Customer has 4 x play one’s throughout the house and a amp powering some ceiling speakers in the garden office. He also has a boost installed. I have added them via sddp and it loads the room details etc, I have identified them via there ip addresses (although they all still show offline). Controller is ea1. I can’t for the life of me get sonos on the touchscreen,sr260 or ea1 ui, probably/hopefully something simple I’m missing, many thanks