squaredroot

A customer has a lot of Somfy shades throughout their house (20+). I initially got them programmed and working great. They would come up at 9AM and go down at 8:30PM, or whenever a particular light switch was pushed 3x on (for shades up) or off (for shades closed). Recently, one shade needed repaired and another was installed in the kitchen. I added the shades to the Somfy Tahoma like I did all the other shades, but now I can't get these two new shades to work with the programming commands of any of the other shades. For example... 1. The new shades will open/close at a specific time if they are the only shades in schedule. 2. The new shades will also open/close if they are the only shades programmed to open/close when the light switch is pressed 3x on or off. But if I add any of the previous shades to the programming, the new shades will not open or close but all the other shades will work from the programming just fine. If a programming event attempts to open or close the newer shade, they appear closed in the touchscreen and mobile app even though the shade doesn't receive the open/close signal. The shade will always open/close just fine when controlled manually from the touchscreen or app. I'm really scratching my head with this one. I've tried deleting the shade and re-adding. I've tried rebuilding the device table. The only thing I feel I haven't tried is removing all the blinds and starting over...which I don't want to do. Any ideas?

I have the T10 thermostat and it’s working great. You can’t create schedules from the touchscreen/UI. That needs to be done in the Resideo app but I can see the temperature and adjust the thermostat just fine through C4. I had Ecobee in the past (without C4 integration) and found it to be very flakey. The driver is free and takes only a few minutes to setup.