Jump to content
C4 Forums | Control4

B&K Ref50 IR Driver


strange_brew

Recommended Posts


try a resistor on the ir line. it may be to much noise comming down that line... I had this issiue on ref 50s and 507's with speakercraft and Xantech ir repeaters... i used to use a lower ma power supply and it would fix it, or id put a resistor in the ir line and usually id get great results.

First try a flasher on the front panel and make sure you codes are good. i have had bad 3.5 mm ports on b&K gear before so could be that too.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...