Bobbss Posted January 17, 2015 Share Posted January 17, 2015 I have programmed the LEDs on switches near outside doors to both be red when the security system is armed. I've not found a good way to put the LEDs back into a "normal" state (top on with light on, etc) when the system is disarmed - is there a quick way to restore the switch default? Composer HE 2.6.0 Thanks Bob Link to comment Share on other sites More sharing options...
Bobbss Posted January 17, 2015 Author Share Posted January 17, 2015 I found another post that gave me the answer - no need to answer - thanks. Bob Link to comment Share on other sites More sharing options...
prabeau Posted January 17, 2015 Share Posted January 17, 2015 could you share that post ThanksP Link to comment Share on other sites More sharing options...
Bobbss Posted January 17, 2015 Author Share Posted January 17, 2015 Here it is, obvious but was hoping a more elegant method: http://www.c4forums.com/topic/15358-led-light-switch-programming/?p=132666 Link to comment Share on other sites More sharing options...
eggzlot Posted January 17, 2015 Share Posted January 17, 2015 As that thread says....if you program it based on the state being armed, program the LED colors when the alarm state is not on. For me, my alarm state for being home is either Stay (motion sensor off) or Away (motion sensor on) and Disarm (no alarm) or Alarm which means the alarm is going off. So for Stay/Away i programmed LED's to be red on the bottom, etc and for Disarm I programmed it without Red LEDs. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.