C4 Thermostat

[innovativehomes]

I have a Control4 Thermostat and on the back it has three small switches (dip switches) and they are labeled but not very clearly. I am looking for an installation guide or something which describes which position is on/off and exactly what they do. Thanks for any assistance.

[Ultimate]

On the back of the thermostat faceplate, set the slide switches that sit

next to the battery compartment to match your system:

a. Set the Mode (botton) switch to select a system type.

Conventional: Set for Conventional heating and cooling systems (default)

Heat Pump: Select for Heat Pump systems

b. Set the Primary (middle) switch to select primary stage fan control.

Fuel: Gas or oil furnace equipment controls fan in heating

(default)

Electric: Thermostat controls fan in heating

c. Set the Secondary (top) switch to select secondary stage fan control.

Fuel: Gas or oil furnace equipment controls fan in secondary

stage heating (default)

Electric: Thermostat controls fan in secondary stage heating

Install the CR123A (3V) battery (included with the product) in the

Control4 thermostat faceplate according to the polarity labels, POS (+)

and NEG (-), on the thermostat circuit board.

IMPORTANT! Do not install the battery in the wrong polarity.

IMPORTANT! If the battery was in place and you changed slide

switch settings, remove the battery and reinstall it. This forces the

thermostat to reboot with the new configuration.