Jump to content
c4forums | The Control4 Community

HDMI Switch


Recommended Posts


What I'm wanting to do with this is move some of my components to a remote closet to clean up one of my cabinets as well as allow more room to grow.  Also this would make it easier to try out new gear.  I have a controller and ethernet in the closet I'd be using.  I would then run either an HDMI cable or use a balun back to the A/V receiver in that room.  I know a matrix would probably be recommended for this but I really only need it at this location for the moment.  Would using an HDMI switch like shown above with a balun be realiable?  I would also only be doing this with lesser used components.  The DirecTV, Blu-Ray, and AppleTV would be kept local to the AVR.  

Link to comment
Share on other sites

Do the IOGEAR switches have Control4 drivers?

 

I don't believe so, but its IR so should be simple for a dealer.  Its on and off, cycle inputs, or choose them directly I think.  There doesn't seem to be a lot of drivers for lower-end switches, and IOGEAR seems to be nice compared to the normal junk.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...