Jaffacree Posted July 23, 2015 Share Posted July 23, 2015 Hello, I installed a Sure Action SU-WP5BDE Wireless driveway sensor at my house. It has an incoming and outgoing sensor. How would I program the contact sensor? If I run over the incoming then the outgoing the alert plays, if I run over the outgoing then the incoming the alert plays. I have it set up to play only on the incoming. I considered variables, but there is no way to tell composer which sensor gets ran over first, so it does me little good. Any thoughts? Should I just remove the outgoing sensor all together? But then the alert will play still on entering and leaving. I need some ideas!! Thank you!! Link to comment Share on other sites More sharing options...
Matt Lowe Posted July 25, 2015 Share Posted July 25, 2015 you could do a timer set to like 10 seconds that resets a variable. this variable could be used to trigger stop programming. i assume you have to contact sensors to program each would go like this Is variable true? Stopset variable to TrueDo Programming for incoming or out going Start Timer Link to comment Share on other sites More sharing options...
Jaffacree Posted July 25, 2015 Author Share Posted July 25, 2015 Thank you, I will give that a whirl when i get back home. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.