Jump to content
c4forums | The Control4 Community

Replacing a driver


ILoveC4

Recommended Posts

I have to replace two WattBox units. I'm replacing 2 of the IP Controlled units where 8 of the 12 outlets were controllable, with ones where all 12 of the outlets are controllable. Here's my question: I've got a TON of programming, bindings, etc...around all 16 of those controllable ports. Is it possible for me to "swap" the driver of the old unit with the driver of the new unit and not lose all the programming I have in place? I can't imagine trying to recreate all the programming...

Thanks in advance.

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites


As I'm sitting here thinking about it, I'm realizing most of the programming may be around the relays that are bound to the WattBox. I can stomach having to re-bind the relays...if that's all that is required.

Sent from my iPhone using Tapatalk

Link to comment
Share on other sites

  • 1 month later...
  • 3 months later...

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...