Jump to content
c4forums | The Control4 Community
  • 0

HC800 Audio Input and Speaker Points


hunger

Question

I was hoping it is possible to route analog audio from the RCA jack audio input on my HC800, using the audio encoder in the HC800 (assuming such a thing exists), to speaker points around the house. If so, how would I get that audio input to show up as an available audio source in the various rooms with speaker points? If not, how could I do such a thing?

Link to comment
Share on other sites

2 answers to this question

Recommended Posts

You can, one would simply add a driver for that source (if you want to use it for a computer or a local 'plug-in' for a phone etc, a no - control driver could be used) into the system, it will show up without further 'work' everywhere you have 'C4 audio' available (meaning where you have a speaker point, or a controller feeding an amplifier or receiver).

However, note that it WILL cause a delay on the audio, and thus this will NOT work for video source.

Link to comment
Share on other sites


Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...