Jump to content
c4forums | The Control4 Community

Tv Watch


Tw!st

Recommended Posts

Hi,

probably a stupid question but here i go, i did a list of channels in Media-UHF_VHF, everything is fine with that, but if i turn the room off and then go straight on , for example, channel 4 HD[104], the tv is turning on and after that is doing only 04, because the number 1 is used to turn the tv on . Is there any way to do something like : press watch - turn tv on - and then delay the next command until the tv is on ?

Thank you

Link to comment
Share on other sites


 

17 minutes ago, Adrian. said:

Hi,

probably a stupid question but here i go, i did a list of channels in Media-UHF_VHF, everything is fine with that, but if i turn the room off and then go straight on , for example, channel 4 HD[104], the tv is turning on and after that is doing only 04, because the number 1 is used to turn the tv on . Is there any way to do something like : press watch - turn tv on - and then delay the next command until the tv is on ?

Thank you

the tv driver should have the power on delay built in but the driver has the power on delay set too short.  Composer Pro is required to fix this.

Link to comment
Share on other sites

Archived

This topic is now archived and is closed to further replies.

×
×
  • Create New...