Jump to content
C4 Forums | Control4
  • 0

Monoprice Blackbird 4K 8x8 HDBaseT Matrix Serial C4 Driver


Amr

Question

3 answers to this question

Recommended Posts


  • 0
On 8/14/2019 at 1:32 PM, nyarjun said:

Good afternoon ... I have this same Matrix reference (Monoprice Blackbird 4k 8x8 Model 24180), but when I try to enter the driver with my technician in the Composer, it makes the connection via IP, but when I send commands it does not send me any type of Signal, can you tell me what kind of procedure I am doing incorrectly?

I was careful to make the connection as indicated in the Driver (1. Turn off the Matrix, 2. Connect the RJ45 Cable, 3. Turn on the matrix, 4. Identify the iP, 5. Install and connect to the Composer) and everything is done successfully, it appears connected, but does not send or control the matrix

I would appreciate if you could help me ... Thank you very much

blackbird4kmatrix.c4i 58.33 kB · 1 download

 

Link to comment
Share on other sites

  • 0

Use this driver to connect serial over ip with the port 4001 & ip address assigned to matrix:
http://www.houselogix.com/shop/free-generic-serial-to-ethernet-driver-4-port

In composer:

Blackbird Driver(RS232)>Free generic serial to ethernet driver

 

Also I would not recommend the matrix for 4k resolution, only seemed to work properly at 1080p for me

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Answer this question...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.