Jump to content
vvtech

Automatically Arm Alarm via Programming

Recommended Posts

I recently got a new alarm and I will like to arm automatically at night and I’m able to set the program to arm, but I don’t see a way to enter the pass code that is required to arm it, so it fails.  Any help here is greatly appreciated.

image.png.fc92c92923358f12e3af713e27eb314f.png

Share this post


Link to post
Share on other sites

also what driver are you using?  As mentioned above, some drivers have the ability to enter the code in the monitoring section of the driver.  I know the IT-100 driver works that way.

Share this post


Link to post
Share on other sites

This is the driver that I'm using.

image.png.f685d2ff121822533df2135920508c05.png

Is this the location to put the code?  I don't see any other areas to add the code in the driver.

image.png.c1ab28cdbf9a59cff7ed1d54c7df2118.png

Share this post


Link to post
Share on other sites
2 hours ago, vvtech said:

This is the driver that I'm using.

image.png.f685d2ff121822533df2135920508c05.png

Is this the location to put the code?  I don't see any other areas to add the code in the driver.

image.png.c1ab28cdbf9a59cff7ed1d54c7df2118.png

I don’t have that driver but yes that looks similar to what I see

i went into my panel and created a code that is only used by c4. It’s not the master or code for any other users

Share this post


Link to post
Share on other sites

So do I need to ask the alarm company to setup a new code to arm the alarm?  I have a VISTA 21IP with 4232CBM Module

Share this post


Link to post
Share on other sites

Again I don’t have your model

with my DSC I can set up to like 15-20 codes on my own.  Not sure about your system

you could use any known code I just thought it was smart to have a unique c4 code in case I wanted to break or change it 

google your model and creating codes and see if you can do it. 

Share this post


Link to post
Share on other sites

It looks like I need a master code to create a new code.  I don't have the master code.

I was hoping it would be easy to arm the alarm with programming. :(

Share this post


Link to post
Share on other sites
2 hours ago, vvtech said:

It looks like I need a master code to create a new code.  I don't have the master code.

I was hoping it would be easy to arm the alarm with programming. :(

There is...don’t use a unique code.  Use the one you know

Share this post


Link to post
Share on other sites
9 hours ago, vvtech said:

I am but not working.

create a macro called arm alarm

have it call out your code - lets say your code is 1234

press 1 on alarm keypad
250 millisecond delay
press 2 on alarm keypad
250 millisecond delay
press 3 on alarm keypad
250 millisecond delay
press 4 on alarm keypad

that is your macro

then upon that command you have above just state run macro arm alarm

other than that I have no suggestions.

Share this post


Link to post
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.


×
×
  • Create New...