O Baik Posted May 16, 2019 Share Posted May 16, 2019 I am a newbie in this C4 world. I have HC 800 and 300. Recently, I found my HC 300's power and other lights were gone except the very faint, red light on the wifi indicator. When I looked at the registered controller on my Composer HE, it was only HC 800. My dealer told me that HC 300 is a slave controller. I am planning to replace the HC 300 with the used one I purchased on ebay. In this case, do I have to have the newer HC 300 reprogrammed? To avoid the reprogramming, should I replace the power supply unit only? Thanks, OB Quote Link to comment Share on other sites More sharing options...
msgreenf Posted May 16, 2019 Share Posted May 16, 2019 New controller needs to be added by a dealerSent from my BBF100-2 using Tapatalk Quote Link to comment Share on other sites More sharing options...
O Baik Posted May 16, 2019 Author Share Posted May 16, 2019 7 minutes ago, msgreenf said: New controller needs to be added by a dealer Sent from my BBF100-2 using Tapatalk Thanks for your reply. If I just to switch the power supply of the dead HC 300 by newer one, still my dealer has to add? Quote Link to comment Share on other sites More sharing options...
msgreenf Posted May 16, 2019 Share Posted May 16, 2019 You said you didn't see the 300 in your project so yes. Which is odd. If it's already properly in there no Sent from my Pixel 3 using Tapatalk O Baik 1 Quote Link to comment Share on other sites More sharing options...
O Baik Posted May 16, 2019 Author Share Posted May 16, 2019 47 minutes ago, msgreenf said: You said you didn't see the 300 in your project so yes. Which is odd. If it's already properly in there no Sent from my Pixel 3 using Tapatalk Thanks again. One more question to clarify: Does physical replacement of a slave controller requires reprogramming if the project already had the slave controller properly in. Quote Link to comment Share on other sites More sharing options...
thegreatheed Posted May 16, 2019 Share Posted May 16, 2019 To clarify here, you said you "looked at the registered controller on my Composer HE". If you looked in account services, only the master controller gets "registered", and you would only see the HC-800 there. If you were looking in the Monitoring tab in HE, you should see the slave HC300 there if it's in the project, but this isn't "registration". Only 1 controller gets "registered". Every controller should show in the project. To answer the question, replacing the power supply wouldn't cause the need for any programming or re-identifying of the controller if the HC300 is in the project already. O Baik 1 Quote Link to comment Share on other sites More sharing options...
O Baik Posted May 16, 2019 Author Share Posted May 16, 2019 6 minutes ago, thegreatheed said: To clarify here, you said you "looked at the registered controller on my Composer HE". If you looked in account services, only the master controller gets "registered", and you would only see the HC-800 there. If you were looking in the Monitoring tab in HE, you should see the slave HC300 there if it's in the project, but this isn't "registration". Only 1 controller gets "registered". Every controller should show in the project. To answer the question, replacing the power supply wouldn't cause the need for any programming or re-identifying of the controller if the HC300 is in the project already. You are right about the registered controller and I was able to see the slave HC300 in the Monitoring tab. Thanks for clarification and explanation. Now things became very clear to me. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.