Jump to content
C4 Forums | Control4

Oppo BDP-103 IP driver


Recommended Posts


 

19 minutes ago, mujtaba.khokhar said:

https://annex4.link/drivers/udp-203

This one is for the 203, but i rekon it could work for the 103 too. 

Worth a shot 

Thanks

Muj

The protocol was the same across TCP and Serial for the 203. It was also just an extension on existing APIs. If the TCP port is open and supported on the bdp the driver should work with TCP commands as well.

Link to comment
Share on other sites

11 minutes ago, Rexabyte said:

 

The protocol was the same across TCP and Serial for the 203. It was also just an extension on existing APIs. If the TCP port is open and supported on the bdp the driver should work with TCP commands as well.

Thanks Muj and Rex for the suggestion.

I did try the annex4 UDP-203 driver. Serial control seems to be working most of the time (it misses the power on / off command once in a while). However, IP control does not seem to work at all. I did set the IP in the Connections -> Network section.

You mention the TCP port needs to be open. Is this a setting on the BDP I need to change?

 

Saurabh

Link to comment
Share on other sites

On 1/26/2021 at 6:24 PM, Rexabyte said:

 

The protocol was the same across TCP and Serial for the 203. It was also just an extension on existing APIs. If the TCP port is open and supported on the bdp the driver should work with TCP commands as well.

Rexabyte,

From the debug output, it seems like the driver is sending commands to port 23. For the BDP-103, the open port is 48360.

Would it be possible for you to modify the driver such that the port can be input manually?

Saurabh

Link to comment
Share on other sites

This thread is quite old. Please consider starting a new thread rather than reviving this one.

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.

Guest
Reply to this topic...

×   Pasted as rich text.   Paste as plain text instead

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...

Important Information

By using this site, you agree to our Terms of Use.