derickson1472 Posted September 22, 2008 Share Posted September 22, 2008 Hi,I have one dimmer in my house that has stopped responding to the Control4. It works manually, but not when you use the control4.Is there a way you can have it 're-set', to see if it can get communications with Control4 again?As always, thanks everyone for your help!!!ThanksDave Link to comment Share on other sites More sharing options...
jem Posted September 23, 2008 Share Posted September 23, 2008 To reset the dimmer:Press the top button 9 times.Press the bottom button 9 times.Press the top button 9 times. Link to comment Share on other sites More sharing options...
henniae Posted September 23, 2008 Share Posted September 23, 2008 15up Reboot device. (tap the top button 15 times)9-9-9 Factory Reset. (tap top button 9 times, tap bottum 9 times, top 9 times)7-4-7 Check zigbee channel. (tap top button 7 times, tap button 4 times, top 7) Link to comment Share on other sites More sharing options...
derickson1472 Posted September 23, 2008 Author Share Posted September 23, 2008 The reboot worked...thanks! Link to comment Share on other sites More sharing options...
henniae Posted September 23, 2008 Share Posted September 23, 2008 Glad it worked.One other thing that you could have tried was to just flip the circuit breaker and power cycle the switch, thus rebooting it. Link to comment Share on other sites More sharing options...
bjt Posted September 23, 2008 Share Posted September 23, 2008 there is also an air gap tab at the top of the dimmer. Slide it upwards with your fingernail to cut the power to the device and leave it for a few seconds. Slide it back in place and it will reboot. This is on the dimmer only. Switches and keypads don't have it. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.