C4User4

installed Gira REG  and it worked somehow. The thing is that after adding switch to project i needed to switch it on and off from ets, and only after - light switch become conttollable.

12 hours ago, Kaas Mayer said:

x1 hasn´t the ability for knx ip gateway/routing.

 

you need to get an ip gateway like ABB IPR/S 3.1.1, Gira REG plus or similar

Thank you. And Thanks for everyone replyed. Will try another router

On 10/5/2022 at 4:25 PM, mujtaba.khokhar said:

Have you used the wizard and imported via your KNX project? 

When using import it imports devices such as sensors and butons. I thought it will import gropu addresses.

20 hours ago, Kaas Mayer said:

what knx router are you using? not all will work.
Use KNX Routing Gateway and check the ets group address monitor. 

post the results here. that will identify the problem

knx is a little bit tricky within c4

I used Gira X1 and openRB Logic Machine 5. Will try it too tomorrow.

On 10/5/2022 at 4:25 PM, mujtaba.khokhar said:

Have you used the wizard and imported via your KNX project? 

Not used yet. I will try tomorrow.

Hi. Composer 3.3.1 and a few KNX ip routers. Gira X1 as one of them and KNX control doesn't work at all.

Doesn't matter Tunnelling or Routing driver. 

Driver shows that connection established but in Switch of Dimmer it doesn't work

and driver satus is blank.  Where can be the problem? Ets connects to the both ip routers well.

Please help ! )

Yes. Thank you. You've explained right to what i asked.

Hello everyone! Have Samsung IR driver in Library for QE series and i do not like how its done. There are 3 pages with buttons and some buttons we dont need. Is it possible to change what page will show first? It looks like for me that i need to write a new driver from the scratch...

Good day everyone. Have very old system with Video and Audio matrix controlled by IR. And its powering on is very slow about half a minute. And also have E3 + Neeo remote. Iы it possible to make freeze to control by neeo for that time and show pop-up about it on screen? I have some drivers writing a long time ago. Do i need to rewrite some drivers maybe and make delay on its or is it possible to make some tricks  with composer programming?

Do you still have it? i need just one.