RegicideCPT Posted February 13, 2018 Share Posted February 13, 2018 Hi Gents. I've got an issue on site at the moment that has been persisting for the last 2 months. Install:5 x dimming panelized modules3 x switching panelized modulesEach type running through a C4 done all switch. Problem:We have intermittent failure on the switching modules.Module 1 fails and modules 2 and 3 work.Physical reset... 6 to 24 hours later module 3 fails and 1 and 2 work. What do I mean by fail:There is no fault detected in composer.A physical switching on the module yields no actual switch. There is no "click" to show a change of state. However the light changes from off to on or vice versa after about 2 seconds. Yet the load does not follow. The only resolve is a physical reset using the button on the module. What we have tested this far?New routerNew luxul 24 port switchNew c4 switchStatic IP on the switching modulesDhcp on switching modulesAdding them to the project via both of the above.Adding them via uddp. Checked network connectivity across entire network.Check outgoing loads as well as incoming. We are stumped and no one seems to have any idea what the issue could be. The funny part is that all dimming modules have never had an issue???And we have one switching module in another section on the home with pool pump and rim flow connected and it's rock solid. Has anyone experience this? Sent from my SM-N950F using Tapatalk Link to comment Share on other sites More sharing options...
Question
RegicideCPT
Hi Gents.
I've got an issue on site at the moment that has been persisting for the last 2 months.
Install:
5 x dimming panelized modules
3 x switching panelized modules
Each type running through a C4 done all switch.
Problem:
We have intermittent failure on the switching modules.
Module 1 fails and modules 2 and 3 work.
Physical reset... 6 to 24 hours later module 3 fails and 1 and 2 work.
What do I mean by fail:
There is no fault detected in composer.
A physical switching on the module yields no actual switch. There is no "click" to show a change of state.
However the light changes from off to on or vice versa after about 2 seconds. Yet the load does not follow.
The only resolve is a physical reset using the button on the module.
What we have tested this far?
New router
New luxul 24 port switch
New c4 switch
Static IP on the switching modules
Dhcp on switching modules
Adding them to the project via both of the above.
Adding them via uddp.
Checked network connectivity across entire network.
Check outgoing loads as well as incoming.
We are stumped and no one seems to have any idea what the issue could be.
The funny part is that all dimming modules have never had an issue???
And we have one switching module in another section on the home with pool pump and rim flow connected and it's rock solid.
Has anyone experience this?
Sent from my SM-N950F using Tapatalk
Link to comment
Share on other sites
0 answers to this question
Recommended Posts
Archived
This topic is now archived and is closed to further replies.