Jump to content
C4 Forums | Control4

Programming a wakeup with a t-stat

Recommended Posts

During the winter I upgraded from 1.73 to 1.74. The dealer did this with ease and all seemed fine. In the past I have my HVAC system hooked up with C4 via motions, alarm set on/off . When no motion for a period of time the room lowers or raises the temperature depending on what time of year,, etc,

Well today I decided to service the a/c and tweak some of my existing programming. My t-stats just don't respond to anything.

I have enclosed a few screen shots. One of my programming once of the wake up and one of the t-stat, Please note I am unable to sync my t-stats up with C4. The time is off and every time I go into properties and then to view/enter schedule I have remove the check marks under enable program.

Any suggestions?

Thanks for your time


Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.