Jump to content
C4 Forums | Control4

HC-300-E-B . How to factory default ???


Recommended Posts

I have a HC-300-E-B with 1.3.2 , after i upgrade to 2.2.4 by USB-Restore but it occur problem. Now , when i power on HC , its still blink orange WIFI status LED ... i read doccument for factory default but on the back of the device i dont see the small hole ( to the right of the Audio In jacks ) so i cannot factory default

anybody can help me for the problem so device work normal !

Thanks so much

Link to comment
Share on other sites

  • 3 weeks later...

Did you read the release notes on the upgrade process, are you saying the controller was on 1.3.2? If so you could not upgrade straight to 2.x, you had to upgrade to 1.7.x, then to 1.8.x, then finally up to 2.x. I believe that is the upgrade path you have to follow.

Link to comment
Share on other sites


This topic is now archived and is closed to further replies.

  • Create New...

Important Information

By using this site, you agree to our Terms of Use.