Joe Hettiarachchy Posted December 10, 2014 Share Posted December 10, 2014 I have been noticing sluggish performance with a brand new HC-800-BL1 and I was wondering if some old loops in my programming were causing the problem. I removed all loops, reset the controller to factory defaults, reloaded 2.6.0, and even with factory settings and no programming loaded into the controller, sysmand logfile reports the error in the subject line every few seconds. Is this normal behavior, or is there something screwy going on with the HC-800? Once I reloaded all my programming (without any loops), the errors continue and the controller continues to be sluggish. Thanks for any help. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.