tebery Posted January 22, 2011 Share Posted January 22, 2011 I last set up my tstat 3 1/2 years ago and never touched it since, but it seems 2.0 wiped the setting clean and I really dont remember how I did it last. Also it seems the advanced configuration is different.The cut off point is set to '0' and all the other settings are at the default settings.Say I have the tstat set to 68 heat, the temp is reading 66, but it is not calling for heat. Raising it to 70 will call up heat, but it seems to be shutting down at 2 degrees less than what it is set for. Link to comment Share on other sites More sharing options...
henniae Posted January 22, 2011 Share Posted January 22, 2011 Needs to be calibrated. there is a setting for that. Link to comment Share on other sites More sharing options...
tebery Posted January 22, 2011 Author Share Posted January 22, 2011 I may be wrong, but as far as calibration, doesn't the set point go off the temp that is being displayed?i.e., if you set the stat to 68 heat, shouldn't it heat till the displayed temp gets to 68? Even thought the temp may not be accurate, it should shut down till it reads 68. Link to comment Share on other sites More sharing options...
henniae Posted January 22, 2011 Share Posted January 22, 2011 Post a screen shot of your settings. Might need to adjust the over shoot. Link to comment Share on other sites More sharing options...
Recommended Posts
Archived
This topic is now archived and is closed to further replies.